Notice

These are extras from our Q1 2026 Neo/QK Preorder
ETA is not precise but expected to fulfil in April
Only pre-determined, fixed configurations are available.

Resource files & guide can be found here: https://qwertykeys.notion.site/Neo-Ergo-Build-Guide

• Case (Top + Bottom + Kernel + Weight)
  • Including one pre-installed external weight 
  • Including one pre-installed kernel
  • Two 2200 mAh batteries will be installed inside of the kernel part for orders with Tri-mode PCBs
    
• PCB kit
  • Tri-mode PCB with 2.4Ghz Dongle
  • 1x PE sheet
  • 1x PCB Foam
    
• Plate
• Poron case foam
• PCB Daughterboard and magnetic connectors - pre-installed
• Gaskets
• Rubber feet
• LED diffusers
• 4 Case corner protectors - installed
• Acrylic / Wooden Wrists Rest (need add ons)
• Free Gifts (Disclaimer: If one of these gifts is missing or is damaged, they will not be replaced):
  • Keyboard carrying case
  • 1x Keycap & Switch puller
  • 1 set of PCB clip-in NeoStab
  • USB-C cable

Supported Layout:

IIf you are unsure about keycap compatibility, please WhatsApp or WebChat us to check for you :)

❗ Due to the ergonomic shape of the wrist rest, a significant amount of cutting and manual polishing is required. As a result, they cannot be completely flat like aluminum. We recommend using it on a desk mat. Alternatively, you can also attach larger anti-slip pads to the back of the wrist rest to increase the contact area. 

The acrylic wrist rests have undergone manual polishing, so minor scratches, slight unevenness, and a few impurities are inevitable and therefore not covered under after-sales service. The quality control standard is that under natural light and within a viewing distance of 30cm, no obvious defects should be visible.

If the acrylic wrist rest gets dirty, please clean it with water. Avoid using alcohol on acrylic products.