Free Shipping (lower 48)

3 - In Stock

For 2011-2016 Powerstrokes

- Increases throttle control through longer accelerator stroke, great for sled pulling

- Lever rides on sealed ball bearings for extremely smooth operation

- Handle throw is approximately 6.1 inches

- Adjustable throttle lever hard stops, comes preset

- Optional integrated and adjustable WOT switch available

- Handle grip pushbutton: latching is standard, momentary optional.

• Latching: push and release latches button ON, push-and release again turns OFF.
  • Example uses: torque converter lockup, nitrous, and etc.
• Momentary:  push and hold for ON, release for OFF.
  • Example uses: hydraulic steering system.

- The pushbutton comes pre-wired to a spring clamp terminal block inside the housing, all you need to do is wire your accessory/device to the terminal block and your ready to go.

- Pushbutton is a high quality sealed, dustproof (MIL-PRF-8805 Design 3), billet aluminum bodied button that offers a mechanical life beyond 50,000 cycles (MIL-PRF-8805).  The quality of this button meets military standard (MIL-PRF-8805).

- Optional wire harness for quick plug-and-play installation.  This wire harness plugs into the trucks OEM harness, extending it to the hand throttle which eliminates the need of cutting/extending the trucks chassis side wire harness.  Built in-house with OEM spec. terminal pins, wire seals, and connectors and has no splices.  The length is 64 inches.

- Utilizes new OEM (FORD) pedal sensor components for reliability

- Uses OEM electrical connector (must extend OEM harness or purchase optional in-house built extension harness)

- 100% designed, machined, assembled, and tested in-house

- Please note, the hand throttle must be mounted next too or near the drivers seat - due to handle throw distance, it cannot be mounted in front of, for example, a bench seat because the handle will hit the radio/dash at wide open throttle.  Please consider this prior to placing an order.

DOWNLOAD INSTALLATION INSTRUCTIONS