0 265 951 840

• EBCM is free and clear of rust or corrosion.

Fits 2009-2014 Ford F-150 models with an exact part number match. If you do not match this you more than likely will get a no communication situation and may surge and kill the board. 

• EBCM will require programming to your vehicle and is not plug and play. Any mechanic in your area that works on Ford's should be able to calibrate it to your vehicle.
• Prior to purchase please verify your wheel speed sensors are good or have been replaced and that your wiring harness has no breaks as both of these situations can set trouble codes. 

Module has been tested by our experienced technical staff! Some of those tests are listed below:
• Module powered up and has communication
• All Traction control switching valves test good
• All Traction control priming valves test good
• All Outlet valves test good
• All Inlet valves test good
• All solenoids test good

Please follow below for proper installation of module:
• Disconnect the negative terminal of the battery. Make sure the battery connector is not touching the battery post.
• Disconnect and remove module to be replaced. Make sure connector harness is clean and there are no broken wires. 
• Install and connect the replacement module. 
• Connect the negative terminal of the battery.
• Module will now need to be programmed/calibrated to your vehicle

• This EBCM carries a 3 month warranty from the date of purchase. Please keep a copy of your sales record which we will send with your order.